treevietnam.blogg.se

1. #MAC TERMINAL EMULATOR 9600 BAUD SERIAL#
2. #MAC TERMINAL EMULATOR 9600 BAUD SOFTWARE#
3. #MAC TERMINAL EMULATOR 9600 BAUD BLUETOOTH#
4. #MAC TERMINAL EMULATOR 9600 BAUD SERIES#

If your network is live, make sure that you understand the potential impact of any command. All of the devices used in this document started with a cleared (default) configuration. The information in this document was created from the devices in a specific lab environment. To identify the type of cable you use, refer to the document RJ-45 Cables or the Cabling Guide for Console and AUX Ports. Rollover cables and straight-through cables have pinouts that are different than crossover cables, which can connect 10/100BASE-TX Ethernet ports between switches. The cable you use depends on the type of Supervisor Engine and other factors. These switches require the use of either a rollover or straight-through RJ-45 cable to connect a terminal to the console port. There are no specific requirements for this document.

#MAC TERMINAL EMULATOR 9600 BAUD SERIES#

For more information on the use of different connection speeds, cables, or devices, refer to the Multilayer LAN Switches hardware and installation guide for your Catalyst series switch.

#MAC TERMINAL EMULATOR 9600 BAUD SERIAL#

It simply appears as a serial stream that you can communicate with exactly as you would with any other serial device.This document focuses on use of the default parameters to connect and configure management terminals.

#MAC TERMINAL EMULATOR 9600 BAUD BLUETOOTH#

I’ve used this method to connect to the sparkfun Bluetooth Mate Gold. Once you’ve connected to the serial bluetooth device with screen, the connection will be held active for the length of your session. Then you will be able to see the device in the list of devices.

You must simply make sure that the bluetooth device is paired and active. This method works equally well if you want to connect to a serial bluetooth device. Press “y” and you’ll be back to your shell terminal. Screen will then prompt you to quit and kill all of your windows. To exit (and close the screen gracefully) press: control-a Once you’ve connected, you can use the terminal as you normally would.

Remember to specify the speed (baud rate) after the device name. Once you’ve determined which device you would like to use, you can execute the SCREEN command to start the serial terminal session on your Mac. The first thing to do is determine which device you want to connect to. This works well particularly if you have an RS-232 serial to USB converter.

#MAC TERMINAL EMULATOR 9600 BAUD SOFTWARE#

There are a few software apps out there, but I find it much simpler to simply use the terminal application “screen”. If you develop on an Apple and find yourself doing any sort of device or embedded development, you will quickly find the need for a serial terminal on Mac.